Menu Preferences - Runco Video Xtreme VX-40d Owner's Operating Manual

Section 3: Operation
Menu Preferences —
SUBMENU
Use the options in this submenu
to adjust the appearance, content
and/or location of on-screen menus
and messages.
LARGE MENU FONT — Enter a
checkmark to enlarge menus and
their text. You may have to adjust "Menu Location" to accommodate the increased menu
area.
MENU LOCATION — Use the pull-down list to choose a pre-defined default or customized
location for the display of all on-screen menus.
To create a custom menu location quickly, choose a preset that is closest to the desired
location. Then adjust "Horizontal Shift" and "Vertical Shift" slidebars to move the menu to
the desired location. Avoid locations too close to a corner or edge to prevent cropping of
larger menus.
HORIZONTAL SHIFT AND VERTICAL SHIFT — Shift your menus as desired, creating
a customized menu location.
DISPLAY CHANNEL LIST — Enter a checkmark if you want to see a scrollable channel
list whenever you press Channel from your presentation. Channels marked with a list
icon in the Channel Setup menu will appear here. The "Display Channel List" option also
enables on-screen feedback when using the Input key. If you prefer to hide the channel
list and input dialog box while switching channels and sources during a presentation, clear
the checkbox.
NOTE: The Channel List and input dialog box cannot be hidden during use of the
menus.
DISPLAY SLIDEBARS — Enter a checkmark to superimpose a small slidebar over the
current image whenever an adjustable parameter is selected directly with a key such
as Contrast or Bright . If "Display Slidebars" is unchecked, these slidebars can still be
accessed, but will be hidden during adjustment. This option does not affect slidebars in
menus.
DISPLAY ERROR MESSAGES — Choose in what way you want to be notified of errors
detected in either the incoming signal or projector. Select "Screen" or "All" to see a brief
on-screen message or select "RS232" to receive messages via RS232 (or RS422) serial
communication only. Select "Off" to hide error message displays. Since the DHD Controller
uses the RS-232 port, Runco recommends this be set to 'screen'.
58