Runco Video Xtreme VX-40d Owner's Operating Manual page 24

Section 2: Installation and Setup
YPbPr signals
(COMPONENT VIDEO)
NOTES:
1) If, for some reason, the projector fails to recognize a signal as an RGB signal, specify
this Color Space option within the Image Settings menu. Refer to Section 3.5,
Adjusting the Image.
2) To connect YPbPr signals – such as from DVDs or analog HDTV sources – to
INPUT 1, use the red, green and blue BNCs as described in YPbPr Signals (below).
Connect a YPbPr signal (component video) to INPUT 1 or INPUT 2 as shown in
➤
Figure 2.11.
NOTES:
1) If, for some reason, the projector fails to recognize a YPbPr signal, specify this Color
Space option within the Image Settings menu. Refer to Section 3.5, Adjusting the
Image.
2) Do not connect digital component signals (known as YCbCr) to INPUT 1. Install an
appropriate optional module in INPUT 5 or INPUT 6 for this.
Figure 2.10 Connecting RGB and Sync
Figure 2.11 Connecting YPbPr sources
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual
16
Fron DHD
Controller