Runco Video Xtreme VX-40d Owner's Operating Manual page 68

Section 3: Operation
COLOR SATURATION: Use this
submenu if you do not have specific
color coordinates in mind and will
simply judge color performance
by eye (or meter). Like the Color
Adjustment by X,Y submenu, each
color control actually defines new
x/y coordinates for that color and
changes its hue — it is just a different
interface.
Adjust the hue of each primary color
(red, green, blue, and white) by using
more or less of it in relation to the
other colors.
Figure 3.17. Customize Color
NOTE: A Color Saturation adjustment sets the corresponding x/y coordinates shown
in the Color Adjustment by X,Y submenu. These x/y coordinates will remain stable for
this User gamut until they are changed again via either menu. Values displayed in the
Color Saturation menu, however, will likely fluctuate as you use the projector, and will
be different when you return to this menu at some point in the future. These floating
changes do not affect the x/y coordinates or gamut.
Test Pattern
Diagnostics and Calibration ➤
Choose the desired internal test
pattern to display or select OFF to
turn off a test pattern. Alternatively,
use the TESTP button on the
remote control for cycling through
test patterns.
NOTE: Runco recommends that all
calibration parameters (grey scale,
sizing, etc.) be done with external
test patterns.
Test Pattern Grey Level
Set the desired level of grey for displaying in the full gray field test pattern.
Freeze Image
Enter a check mark to freeze (stop) an image on a single frame. This diagnostic tool is
useful if you need to examine in detail a still version of an incoming image that cannot
be "frozen" at the source. For example, in moving images it is sometimes difficult to
observe artifacts such as external deinterlacing/resizing and signal noise. Remove
the checkmark to return back to normal.
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual
60