Runco Video Xtreme VX-40d Owner's Operating Manual page 25

Section 2: Installation and Setup
INPUT 3 and INPUT 4 provide simultaneous connection of both a composite video
Composite and S-Video
source (INPUT 3) and an S-Video source (INPUT 4), though typically these connections
would be made at the DHD Controller. See Figure 2.12.
Figure 2.12 Connecting Composite or S-Video sources
Use the DVI-I connector at INPUT 2 to connect either analog or digital video devices to
DVI Digital Video
the projector. You can connect the DHD Controller here as well; if you do this, change the
Display Device setting on the DHD Controller to DVI.
Use a cable with DVI-I connectors at both ends to connect devices that transmit digital
and analog video signals such as high-quality DVD players, satellite receiver and digital
cable TVs.
NOTES:
1) To ensure true digital output from devices that transmit digital signals, connect to the
DVI-I connector.
2) DVI loop through is not available unless you have the optional DVI Input Module
installed at INPUT 5 or INPUT 6.
Refer to Appendix D, Optional Input Modules, for a list of available optional input
Optional Inputs
modules.
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual
17