Replacing Remote Batteries; Lamp And Filter Replacement - Runco Video Xtreme VX-40d Owner's Operating Manual

The optional IR remote uses four AAA size, 1.5V alkaline batteries. To replace the batteries
simply turn the remote over and remove the battery cover.
Remove and properly discard the old batteries. Insert new batteries in the proper positive/
negative orientation as shown etched in the bottom of the compartment (2). Replace the
cover by inserting the tabbed end into the opening and snapping the opposite end into
place.
1
Figure 4.1. Replacing remote batteries (underside of keypad shown)
Use the following instructions when replacing the lamp. The lamp is located at the back of
the projector (below the input panel) and can be accessed by removing the lamp access
panel. Use only the Runco approved Lamp and Filter Kit for your specific projector model.
See chart below.
Projector Model
Runco VX-40d
Runco VX-50d
Runco VX-60d
Runco VX-80d
A lamp should be replaced when it reaches its end of life (1000 hours, typical) or
sooner if a noticeable degradation in brightness occurs (typical in aging lamps). You
can set the number of hours you expect to log with the lamp before replacing it, by
setting the Lamp Limit in the Lamp menu. You can also enable a warning message
to appear upon powering up the projector that will indicate the lamp has reached the
limit you set, by entering a checkmark beside the Lamp Message option. NOTE: The
lamp mode you choose to run the projector in may affect the lamp life.
Tools required: #1 Phillips screwdriver
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual
Lamp (Watts) Part Number
1000W RUPA-006400
1200W RUPA-006700
1000W RUPA-006800
1200W RUPA-006850
75
Section 4: Maintenance
4.3 Replacing Remote
Batteries
4.4 Lamp and Filter
Replacement