Runco Video Xtreme VX-40d Owner's Operating Manual page 43

Section 3: Operation
Shown at right is a sample channel list.
CHNL
NOTE: The Channel key may display a channel list
or not, depending on the current "Display Channel
List" setting (refer to Menu Preferences later in this
section).
Channel List
To use a new source with the projector, you must add a new channel to projector
Creating a New Channel
memory so that the projector will respond properly to an input signal from that source
– AUTOMATIC –
in the future. A new channel can be created automatically, as described here, or it
can be copied from an existing channel and then edited as necessary (see Copying
or Deleting Channels later in this section).
When you select a direct input (RGB, DVI, INPT3, INPT4, INPT5 or INPT6) any existing
channels in the projector are searched for matching input and signal parameters – this
only occurs if Auto Source is enabled on these channels. If no match to the incoming
input signal is found in currently-defined channels, a new channel is temporarily created
based on factory-defined defaults for this type of signal. The channel number assigned is
the lowest available number from 01 to 50.
NOTES: 1) An automatic channel will be discarded unless one or more of its parameters
are changed and will not appear in the channel list (see below). 2) If two channels have
the same distinguishing source characteristics except for the reversal of sync connectors
(i.e., H-sync and V-sync, are switched), they are still defined as distinct channels. 3) You
cannot define a new channel without an incoming signal.
If the incoming signal does match an existing channel, the image will be set up and
displayed as usual according to the parameters currently defined for that channel.
USING A CHANNEL: You can
normally select a channel at any
CHNL
time by pressing CHNL (see right).
If you want to prevent a channel
from appearing in this list, you
must edit the channel as described
in Channel Edit later in this section.
Such a channel can still be selected
by entering its number as shown at
right.
NOTES: 1) The current channel is highlighted upon entering the channel list, or, if this
channel is not displayed here, the first channel in the list is highlighted. 2) Channels
created automatically do not appear in the channel list unless a parameter for the channel
has been changed.
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual
35