Runco Video Xtreme VX-40d Owner's Operating Manual page 34

Section 3: Operation
Guide to Keypads ➤
Keypad commands ➤
LCD Menu ➤
Keep in mind the following guidelines:
• Press keys one at a time; there are no simultaneous key combinations required.
• Note that two keys, POWER and MUTE, are "press-and hold" keys that do not
function with a typical quick press-and-release key press.
• Hold arrow keys down for continuous adjustment/movement in one direction.
• If you press a key while the projector is still responding to the previous action,
such as during power-up, the second key press may not take effect.
Specific keypad commands are explained below:
Power ON/OFF
Press and hold for two seconds to toggle the projector on or off with a single keystroke.
Or press and release followed immediately by ▲ (on) or ▼ (off) to guarantee the correct
toggle (useful if you are unsure of the present state).
NOTES:
1) After powering down, the lamp cooling fan remains on for approximately five minutes
to cool the lamp.
2) Avoid turning the projector back on until it has been off for a few minutes. Hot re-
strikes of the lamp may reduce lamp life.
The IR remote has its own menu structure, independent
of the on-screen menus. The IR remote menus provide
convenient shortcuts for selecting the signal source,
operating the lens and performing certain other
projector functions.
26
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual
MAIN
LENS FUNCS
SOURC