Table of Contents
Advertisement
4.6.1
Safety Messages (Review Carefully)
Symbol
Danger:
Caution:
October 2013
DTC1250e/DTC1000Me/DTC4250e Card Printer User Guide, PLT-01668, 1.0
Critical Instructions for Safety purposes
Failure to follow these installation guidelines can result in
death or serious injury.
Information that raises potential safety issues is indicated by a
warning symbol (as shown to the left).
•
To prevent personal injury, refer to the following safety
messages before performing an operation preceded by this
symbol.
•
To prevent personal injury, always remove the power cord
prior to performing repair procedures, unless otherwise
specified.
•
To prevent personal injury, make sure only qualified
personnel perform these procedures.
This device is electrostatically sensitive. It may be damaged
if exposed to static electricity discharges.
Information that raises potential electrostatic safety issues is
indicated by a warning symbol (as shown to the left).
•
To prevent equipment or media damage, refer to the
following safety messages before performing an operation
preceded by this symbol.
•
To prevent equipment or media damage, observe all
established Electrostatic Discharge (ESD) procedures while
handling cables in or near the Circuit Board and Printhead
Assemblies.
•
To prevent equipment or media damage, always wear an
appropriate personal grounding device (e.g., a high quality
wrist strap grounded to avoid potential damage).
•
To prevent equipment or media damage, always remove
the Ribbon and Cards from the Printer before making any
repairs, unless otherwise specified.
•
To prevent equipment or media damage, take jewelry off
of fingers and hands, as well as thoroughly clean hands to
remove oil and debris before working on the Printer.
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
Page 35
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
