HID Fargo DTC1250 User Manual page 44

DTC1250e/DTC1000Me/DTC4250e Card Printer User Guide, PLT-01668, 1.0
Setting
Flipper Home Offset
Flipper Eject Height Offset
Mag Super-Co Voltage Offset
Mag Medium-Co Voltage
Offset
Head Home Offset
Head Print Offset
Head Contact Offset
Head Queue Offset
Head Card Thickness Offset
Head Smart Card Engage
Offset
Head Mag Offset
Overlay Heat Adjust
10 Mil Card Queue Offset
Erase Speed
Page 44
Description
This setting is a calibration driven value and should not be
adjusted. If the Flipper unit is replaced and has not been calibrated
this value may need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
This setting is a calibration driven value and should not be
adjusted. If the Flipper unit is replaced and has not been calibrated
this value may need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
This option changes the voltage going the magnetic head.
This setting is factory set and should not be changed unless
directed by a technician..
This option changes the voltage going the magnetic head.
This setting is factory set and should not be changed unless
directed by a technician.
This setting is a calibration driven value and should not be
adjusted. If the Printhead assembly is replaced then this value may
need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician
This setting is a calibration driven value and should not be
adjusted. If the printhead assembly is replaced then this value may
need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
This setting is a calibration driven value and should not be
adjusted. If the printhead assembly is replaced then this value may
need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
This setting is a calibration driven value and should not be
adjusted. If the printhead assembly is replaced then this value may
need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
Adjusts the card handling path to allow for variances in card
thickness.
Adjusts the position of the print head to allow smart card encoder
contact.
Adjusts the printhead for magnetic encoding.
Adjusts the temperature setting for overlay film.
Adjusts the input queue for use with thick cards.
Adjusts the speed of the erasure process.
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
October 2013