Uninstalling Swift Id; Additional Swift Id Rules - HID Fargo DTC1250 User Manual

3.1.3.2 Option 2
Step Procedure
1 Install the HID EEM Driver from the driver CD or download the HID EEM Driver installer
file from the support page
2
Run the installation file.
3 When the installation is complete, check the Enable Swift ID over a USB Connection
check box in the Advanced section of the printer driver.
Note: When this flag is checked, a new printer instance appears and the old printer
instance is no longer valid.
3.1.3.3

Uninstalling Swift ID

For a printer installed on a network, no steps are needed to remove any of the components of Swift ID.
For a printer that is connected via a USB connection, deselect (uncheck) the Enable Swift ID over a USB
Connection check box in the advanced section of the printer driver and then run the uninstall HID EEM
Driver setup.
Note: When this flag is disabled, a new printer instance appears and the old printer instance is no longer
valid.
3.1.3.4

Additional Swift ID Rules

The following apply when (a) the HID EEM driver for Swift ID is installed on the PC for a printer and (b) a
second printer with the EEM flag enabled is connected to the PC:
• A Printer instance appears for the second printer; however, a second shortcut for Swift ID does not
appear.
Note: Swift ID is not intended to operate with two printers.
• If both Printers are connected to the PC, the printer that is first powered on is tied into Swift ID.
The following apply when (a) the EEM driver is not installed on the PC and (b) another printer (same model)
with EEM disabled is connected to the PC.
• A printer driver instance appears.
• The User is not asked to enable EEM for the printer.
• The HID EEM driver is not installed for the printer on the PC.
• The EEM flag in the printer driver is 'grayed out' so that the User cannot change this state.
October 2013
DTC1250e/DTC1000Me/DTC4250e Card Printer User Guide, PLT-01668, 1.0
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
Page 29