HID Fargo DTC1250 User Manual page 70

DTC1250e/DTC1000Me/DTC4250e Card Printer User Guide, PLT-01668, 1.0
Error Message
# 111
Head Loading
# 112
Card Jam/Align error
# 128
# 170
Calibrate Ribbon
# 131
Flipper Jam/Home Error
# 136
Secure Guard Print
Disabled
# 139
Please Remove Ribbon
# 144
EEPROM Corrupt
EEPROM Read Error
#202
Encoder not installed
Page 70
Cause
An unrecoverable error has occurred
during printing.
A card is jammed in the print station or
card flipping area of the Printer.
The print ribbon sensor is out of
calibration or has failed.
A card has become jammed in the
printer's fipper table.
The flipper failed to position properly
while aligning a card or flipping a card.
Printing is disabled by SecureGuard
until a password is received.
Ribbon needs to be removed.
EEPROM restored with factory default
values.
You are trying to send encoding data,
but the Printer is not configured with this
Encoder type.
iCLASS,Prox,Mifare,SmartCard
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
Solution
Reset the printer and try again. If this
problem persists, call for technical
assistance.
Clear the jam. Press the Pause button
to continue.
Calibrate the ribbon sensor.
Check for material blocking sensor and
try again.
Clear any cards in the flipper table,
using the buttons to move the card out.
Resume printing.
Reset the printer and retry. If problem
persists call for technical assistance.
Reset the printer and retry.
If the problem persists, call for
technical assistance.
Reset the printer and retry.
If problem persists, call for technical
assistance.
If changes were made in the
Advanced Setting tab in the printer
driver, click the Default button to reset
these numbers.
Reset the printer and try again. If this
problem persists, call for technical
assistance.
Ensure that no encoding data is being
sent with the print job and reprint the
card.
Install an encoding module.
October 2013