Changing The System From Ahci Or Ide Mode To Raid Mode - EUROCOM X7 User Manual

Changing the System from AHCI or IDE Mode to RAID Mode

1. Go to the operable computer and insert a USB Flash drive or external USB HDD.
2. Insert the Device Drivers & Utilities + User's Manual disc into the CD/DVD drive of the operable computer.
3. Copy the f6flpy-x64 folder from the location below (D: denotes your DVD drive) on the Device Drivers &
Utilities + User's Manual disc to the USB flash drive or external USB hard disk.
• Windows 8.1 64bit = D:\Options\00_IRST\f6flpy\f6flpy-x64
4. Start-up your notebook computer and press <F2> to enter the BIOS.
5. Go to the Boot menu, select UEFI Setting and press <Enter> (see page
6. Set UEFI Boot to "Enabled".
7. Press <Esc> to exit the menu and go to the Advanced menu.
8. Select SATA Mode (see page
9. You will then receive the warning message (see
result in needing to reinstall the operating system; press OK to confirm the change.
10. Press <F4> and <Yes> to "Save Changes and Reset".
11. After computer restarts press <F2> to enter the BIOS again.
12. Go to Intel(R) Rapid Storage Technology (in the Advanced menu) and press <Enter>.
13. Select Create RAID Volume and press <Enter>.
Figure 8 - 3
5 - 10), press <Enter> and select "RAID Mode".
- Create RAID Volume (Advanced > Intel(R) Rapid Storage Technology
5 -
Figure 8 - 2 on page 8 - 16) that changing the SATA mode will
Problems and Possible Solutions 8 - 17
Troubleshooting
17).
8