Radius Commands - Avaya C360 Installation And Configuration Manual

Establishing Switch Access

RADIUS Commands

The following RADIUS commands are accessible from Supervisor level.
Table 17: RADIUS CLI Commands
For a complete description of the RADIUS CLI commands, including syntax and output
examples, refer to the Reference Guide for the Avaya C360 Converged Stackable Switch,
10-300506.
82 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
In order to...
Enable or disable authentication
for the C360 switch. RADIUS
authentication is disabled by
default
Set a primary or secondary
RADIUS server IP address
Configure a character string to
be used as a "shared secret"
between the switch and the
RADIUS server
Set the RFC 2138 approved
UDP port number.
Set the number of times an
access request is sent when
there is no response
Set the time to wait before
re-sending an access request
Remove a primary or secondary
RADIUS authentication server
Display all RADIUS
authentication configurations.
Shared secrets are not
displayed.
Use the following command...
set radius authentication
set radius authentication server
set radius authentication secret
set radius authentication
udp-port
set radius authentication
retry-number
set radius authentication
retry-time
clear radius authentication
server
show radius authentication