Layer 2 Configuration File - Avaya C360 Installation And Configuration Manual

Switch Configuration
Note:
*The running configuration is not saved automatically after a reset. If you wish to
Note:
make the currently running configuration the startup configuration, use the copy
running-config startup-config command before preforming a reset.

Layer 2 Configuration File

The Layer 2 configuration file contains the full Layer 2 configuration of the switch in the format of
the CLI commands necessary to configure the device to its current configuration. You can edit
the file in a text editor, however, it is recommended that you perform the configuration changes
using the C360 Device Manager and/or the CLI. To upload or download Layer 2 configuration
files, you must be in a switch mode.
Use the CLI commands described below for uploading and downloading Layer 2 configuration
files. The rules of syntax and output examples are all set out in detail in the Reference Guide for
the Avaya C360 Converged Stackable Switch, 10-300506.
In order to...
Download a module
configuration file to the device
using SCP
Download a stack configuration
file to the device using SCP
Download a module
configuration file to the device
using TFTP
Download a stack configuration
file to the device using TFTP
Upload a module configuration
file from the device using SCP
Upload a stack configuration file
from the device using SCP
Upload a module configuration
file from the device using TFTP
Upload a stack configuration file
from the device using TFTP
100 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
Use the following command...
copy scp module-config
copy scp stack-config
copy tftp module-config
copy tftp stack-config
copy module-config scp
copy stack-config scp
copy module-config tftp
copy stack-config tftp
1 of 2