Allowed Managers; Allowed Managers Introduction; Allowed Managers Cli Commands - Avaya P334T-ML Installation and configuration guid Installation And Configuration Manual

Chapter 8 User Authentication

Allowed Managers

Allowed Managers Introduction

With the Allowed Managers feature, the network manager can determine who may
or may not gain management access to the switch. The feature can be enabled or
disabled (default is disabled). When enabled, only those users that are configured in
the Allowed Managers table are able to gain Telnet, HTTP, and SNMP management
access to the switch.
You can configure up to 20 Allowed Managers by adding or removing their
IP address from the Allowed Managers List.
The identification of an "Allowed Manager" is done by checking the Source
IP address of the packets. Thus, if the Source IP address is modified on the way
(NAT, Proxy, etc.), even an "Allowed Manager" will not be able to access the
P330.

Allowed Managers CLI Commands

The following Allowed Managers commands are available.
In order to...
When set to enabled - only
managers with IP address specified
in the allowed table will be able to
access the device
Add/delete IP address of manager
to/from the allowed table
Show the IP addresses of the
managers that are allowed to access
the device
Show whether the status of allowed
managers is enabled or disabled
Show the IP addresses of the
managers that are currently
connected
54
Use the following command...
set allowed managers
set allowed managers ip
show allowed managers table
show allowed managers status
show secure current
Avaya P334T-ML User's Guide