Table of Contents
Advertisement
Configuring MotherBoard Jumpers
Your system's motherboard has 6 jumper settings:
Clear CMOS jumper
USB POWER jumper (x4)
KBPW jumper
Clear CMOS Jumper (CLRTC)
1. Power off the system and unplug the AC power cord.
2. Set position as 2-3 (Clear CMOS).
3. Wait 2 seconds.
4. Set position as 1-2 (Normal [Default]).
5. Power on the system. The message 'CMOS checksum bad' displays.
6. Press F2 to enter setup.
USB Power Jumpers (USBPW78/ USBPW56/ USBPW34/ USBPW12)
1-2 position: USB power with 5V.
2-3 position: USB power with 5V standby (default).
TM700 User Guide - Configuring Your System
Figure 3 - 1 : Clear CMOS Jumper
Figure 3 - 2 : USB Power Jumpers
3 - 15
Advertisement
Table of Contents
