Light Fixture Installation - Casablanca Reverie Owner's Manual

SWITCH HOUSING HARDWARE (not to scale)
Light Assembly
Light Assembly Installation
Step 11a. Using screw pack "E" and screwdriver provided;
install three screws into the light assembly adaptor plate,
as shown.
Step 11b. Connect the light assembly connector to the
motor connector.
Step 11c. Carefully tuck the wires and align the keyhole
slots in the light assembly with the three screws in the
adaptor plate. Turn counter clockwise to align the keyhole
slots with the three screws.
Step 11d. Securely tighten all three screws by hand only.
Install Incandescent Bulbs
Step 12. Screw in two 60- watt B-10 Candelabra-base
bulbs.
Glass Installation
Step 13a. Remove fi nial and cap from light assembly.
Step 13b. Insert the threaded rod from the light assembly
through the hole in the glass shade, as shown.
Step 13c. Insert the cap, then thread the fi nial onto the
threaded rod. Tighten securely.
CAUTION:
Over tightening the fi nial can cause glass to break.

LIGHT FIXTURE INSTALLATION

Screw Pack E:
Light Assembly Screws (3)
R
EVERIE
60-watt B-10 bulb
(Candelbra-base)
™
Glass Shade
11