Light Fixture Installation - Casablanca Silhouette II Owner's Manual

Hide thumbs Also See for Silhouette II:

Owner's manual (16 pages)

Table of Contents

liGhT FiXTure hArdwAre (not to scale)

switch housing

Step 7a. Insert three switch housing screws (Pack F) into

the screwholes in the center of the motor.

Step 7b. Hold the switch housing up to the motor. Feed

the wires through the center hole and align the switch

housing screws (F) with the keyholes. Twist the switch

housing clockwise.

Step 7c. Tighten all three screws using the screwdriver.

Step 7d. Remove the ceramic wire nuts from the wires

on the socket plate and set aside for use in the next two

steps.

Step 7e. Attach the WHITE wire on the socket plate to

the WHITE wire on the switch housing. Secure with a

ceramic wire nut.

Step 7f. Attach the BlACK wire on the socket plate to the

BluE wire on the switch housing. Secure with a ceramic

wire nut.

Step 7g. Align the three holes on the socket plate with

the screwholes on the switch housing. Insert three socket

plate screws (Pack G) and tighten until secure using the

screwdriver.

Step 7h. Remove the lightbulb shield from the socket plate.

Insert one end of the halogen bulb into the socket. Push the

end of the socket, then insert the other side of the halogen

bulb into the socket. Re-insert lightbulb shield.

Step 7i. Position the indentations in the outer rim of the

glass shade so that they line up with the tabs on the inside

surface of the fan light fixture rim.

Step 7j. Carefully lift the glass shade up inside the light

fixture as far as it will go. Rotate the shade in a clockwise

direction until it is held tightly in place by the three tabs.

CAuTIOn:

The halogen bulb is very delicate and should

not be handled with bare hands. After removing

it from the box, grasp it gently by the plastic

covering or a soft cloth.