Light Fixture Installation - Casablanca WHITMAN Owner's Manual

HARDWARE (not to scale)
Light Fixture
Light Assembly Installation
Step 13a. Locate the light cover board and unscrew
the fi nial from the threaded rod. Set fi nial aside for
glass installation in Step 14.
Step 13b. Locate the three screws on the light
kit mounting plate and loosen them, as shown in
Figure #1. Route the wires from the bottom of the
fan through the hole in the center of the light fi xture.
Then place the three key holes over the three screws
and rotate the light fi xture clockwise, as shown in
Figure #2. Tighten the three screws with the provided
screwdriver.
10

LIGHT FIXTURE INSTALLATION

Light Cover Board &
Bottom Finial
Light Fixture Screws (3)
LOOSEN
SCREWS
Figure #1
Figure #2
Phillips
Screwdriver
SCREWS IN
KEY HOLES