Advertisement
Quick Links
INTRODUCTION
MOUNTING RECOMMENDATIONS
FAN INSTALLATION
CONTROL FEATURES:
INTELI•TOUCH OPERATION
INTELI•TOUCH TROUBLESHOOTING
INTELI•TOUCH 2 OPERATION
INTELI•TOUCH 2 TROUBLESHOOTING
Safety and the proper operation of your Casablanca fan both require a thorough knowledge of the product
and proper installation; therefore, before attempting to install and operate your Casablanca fan, read this
owner's manual completely and carefully. Retain this manual for future reference.
CAUTION: To avoid possible electrical shock, make certain that electricity is turned off at
the circuit breaker or fuse box before attempting any installation procedure.
• CAUTION: RISK OF ELECTRICAL SHOCK! All wiring must be performed in accordance with national and local electrical
codes. If you are unfamiliar with the wiring codes, you should use a qualified electrician. To avoid overheating and
possible damage to other equipment, do not install control to a receptacle, fluorescent light fixture, motor operated
appliance, or transformer-supplied appliance..
• This fan is designed to be installed on an existing electrical outlet box. The outlet box must be UL Listed for ceiling fan
installations, if it is not, a new box must be installed. Casablanca extension poles are available for sloped or high ceiling
installations.
• This ceiling fan requires a grounded electrical supply of 120 VAC, 60 Hz and a minimum 15 amp circuit. The maximum
current requirement for the fan with light fixture is 3.8 amps. The fan uses about 1 amp or 100 watts. Maximum light
current is 2.8 amps or 340 watts of lighting.
• Where wire nuts are employed, be sure all bare wires are within the connectors. When installing the canopy hatch, make
sure all wires are within the canopy and that no wires are being pinched.
For best performance and for your warranty to be valid, use only genuine Casablanca blades, light fixtures, and accessories.
• The blades in each pack are matched for
equal weight to assure smooth fan operation.
If more than one fan is being installed, be
careful not to mix blades from different
cartons.
• Inspect the contents of your carton for
possible shipping or handling damage and
report any such damage directly to your
authorized Casablanca dealer.
• It is always a good idea to have an assistant
to help with the installation.
• When cleaning, painting, or working near
your fan, be very careful of the fan and
blades. Always turn the power OFF to the
ceiling fan before servicing it, working on
it, or replacing light bulbs.
• Never insert anything into the path of the
fan blades while the fan is in operation.
• Never install a fan over a pool or spa.
• Never operate a fan that has been damaged in
any way. Contact Casablanca Fan Company by
calling toll free 1-888-227-2178, or contact
your local authorized Casablanca dealer for
assistance in obtaining service.
CONTENTS
READ AND SAVE THESE INSTRUCTIONS
SAFETY FIRST
BEFORE YOU START
SAFE USE
FUSE BOX
(REMOVE FUSE FOR THE
CIRCUIT YOU WILL BE
WORKING ON)
CIRCUIT BREAKER
(TRIP BREAKER FOR THE
CIRCUIT YOU WILL BE
WORKING ON)
P/N 3843010 REV. G BM0404
12
13
15
18ʺ
70ʺ
84ʺ
1
1
2
3
9
Advertisement
Related Manuals for Casablanca Bel Air Halo
Summary of Contents for Casablanca Bel Air Halo
-
Page 1: Safety First
• This fan is designed to be installed on an existing electrical outlet box. The outlet box must be UL Listed for ceiling fan installations, if it is not, a new box must be installed. Casablanca extension poles are available for sloped or high ceiling installations. - Page 2 MOUNTING RECOMMENDATIONS Before mounting your Casablanca fan, read the following helpful recommendations. The location of the fan, air circulation, and fan size are all important factors to consider before installation. Location Ceiling fans have practical uses in almost every room in your home. We suggest you follow these mount- ing recommendations as you decide where to install your Casablanca fan.
- Page 3 Installing a New Ceiling Fixture Outlet Box If you do not have an existing fixture located where you wish to place your Casablanca fan, an approved ceiling fixture outlet box must be installed and wired. Warning: To reduce the risk of fire, electrical shock,...
- Page 4 CROSSBAR MOUNT- ING BRACKET SUPPORT INSTALLATION PARTS CROSSBAR MOUNTING BRACKET INSTALLATION Note: After removing the old fixture, check the outlet box to insure that it is supported by a joist or beam across its upper surface. If not, a 2” x 4” stud must be installed. Step 1.
- Page 5 Step 4. Attach the canopy to the crossbar mounting bracket with three of the 8-32 x 2 ” long canopy screws and lock washers provided with your Casablanca fan. Hand tighten until snug against the ceiling. Note: On sloped ceilings, align the canopy opening toward the top or peak of the room.
- Page 6 UPPER AND LOWER GLASS PARTS HALOGEN BULB 100 WATT GLASS SHADE INCANDESCENT BULB 60 WATT (3) INSTALLING THE UPPER GLASS SHADE IMPORTANT! To avoid possible damage to the Halogen bulb holder the fan must be placed on the bottom styrofoam packaging from the box. After removing the top half of the styrofoam, take the bottom half from the box and place it on the floor.
- Page 7 Step 9. To hang the fan body in the canopy, hold the fan body firmly and insert the ball into the canopy opening. Check that no wires were pinched. Rotate the fan body until the slot in the ball fits into the pin opposite the canopy opening.
- Page 8 BLADE HOLDER HARDWARE BLADE SCREW (4 PER BLADE) CENTER STYLE BLADE HOLDER & BLADE Step 14. Blade Installation Attach the blades to the blade holders with four blade screws and four steel washers provided for each blade. Hand tighten securely. HALOGEN BULB GLASS SHADE 100 WATT...
- Page 9 For this reason the following precautions must be observed: 1. Use only the Casablanca W-32 wall control. 2. Do not use any additional control with your Inteli-Touch fan (for example, dimmer, fan speed control, etc.).
- Page 10 Inteli•Touch INTELI•TOUCH OPERATION POWER The POWE button is normally left in the on position. Always turn the POWER power off during cleaning or servicing the fan and during thunderstorms. It is also used to exit or enter additional programs. POWER must be left on to retain a previously set fan speed or light level.
- Page 11 INTELI•TOUCH OPERATION LIGHT-MINDER PROGRAM The Light-Minder program automatically turns OFF the fan mounted lights after two hours. To enter the Light-Minder Program: 1. Turn th e POWEROFF for at least three seconds. POWER 2. Turn the 3. Immediately operate the buttons in the following sequence: LIGHT 4.
- Page 12 ™ TROUBLESHOOTING Never Lubricate this Fan! The precision motor at the heart of your Casablanca fan features sealed bearings that are lubricated for life. Do not attempt to oil the motor. Changing Light Bulbs Be sure to turn power to the fan OFF at the wall switch or circuit breaker before changing light bulbs.
-
Page 13: Dual And Single W-82 Installation
For this reason the following precautions must be observed: 1. Use only the Casablanca W-82 wall control. 2. Do not use more than one fan per wall control. - Page 14 Inteli•Touch2 INTELI•TOUCH2 OPERATION LIGHT-MINDER PROGRAM The Light-Minder program automatically turns OFF the fan mounted lights after two hours. To enter the Light-Minder Program: 1. Turn the POWER OFF for at least three seconds. 2. Turn the POWER ON. 3. Immediately operate the buttons in the following sequence: LIGHT 4.
- Page 15 FAN OR LIGHTS APPEAR TO OPERATE BY THEMSELVES (CHANGING SPEED OR INTENSITY), WALL CONTROL OPERATION IS INTERMITTENT: Check AC supply for irregularities, (noise spikes, fluctuations, or failure); or circuit board as- sembly. For questions or to locate the nearest Casablanca Authorized Service Center www.CasablancaFanCo.com OPTIONAL REMOTE CONTROL INTELI•TOUCH2...
- Page 16 ™ ’ WNER ANUAL...
- Page 17 w w w . C a s a b l a n c a F a n C o . c o m 761 C • P , CA 91768 • 888-227-2178 ORPORATE ENTER RIVE OMONA ©C 2004 C • U.S. P OPYRIGHT ASABLANCA OMPANY...