Light Fixture Installation; Optional No-Light Cap Installation - Casablanca La FLeur Owner's Manual

Hide thumbs

Table of Contents

Perma•Lock™ Hardware (not to scale)

Glass Shade

Step 9a. Connect the two-pin connector from the light socket

center stem assembly to the two-pin receptor hanging from

the motor housing.

WARNINg! Do not allow the light socket center

stem assembly to hang by the wire.The fixture could

fall and cause injury or damage the fan.

Step 9b. Thread each of the two provided screws through

a screwhole in the light socket center stem assembly and

a screwhole in the motor housing and tighten using the

provided screwdriver.

Step 9c. Insert a provided 60-watt G-16.5 lightbulb into each

light socket and twist until snug.

Step 9d. Carefully lift the glass up to the light socket center

stem assembly and insert the threaded post of the assembly

into the hole in the glass. While continuing to hold the glass

up with one hand, screw the light fixture finial onto the

threaded post with the other hand.

OPTIONAL NO-LIGHT CAP INSTALLATION

If you choose not to install the light fixture, you must install

the no-light cap finial.

Step 9a. Tuck the wires inside the no-light cap finial, then

twist the finial onto the motor housing until tight.