Light Housing Installation; Light Fixture Installation - Casablanca Bungalow Owner's Manual

™
B
UNGALOW

LIGHT HOUSING INSTALLATION

SWITCH HOUSING HARDWARE (not to scale)
Finial
Pack E:
Light Housing Screws (3)
60-watt B-10 bulb (2)
Pack F: Light Assembly
(Candelabra-base)
Light Housing
Socket Plate Socket Plate Screws (3) Cover Plate
Step 10a. Using the screws from Pack E and the provided
screwdriver, loosely install two screws into the mounting
plate as shown.
Step 10b. Carefully feed the light wires though the center of
the light housing.
Step 10c. Align the screw holes in the light housing with the
screws in the mounting plate. Turn counterclockwise to align
the keyhole slots. Install the third screw into the remaining
hole and tighten all three screws by hand only.

LIGHT FIXTURE INSTALLATION

Step 11a. Using the screws from Pack F and the provided
screwdriver, install each of the three screws into the switch
housing mounting plate as shown.
Step 11b. Remove the rubberband from the light assembly
connector wire. Connect the light assembly connector to
the motor connector as shown.
Step 11c. Align the keyhole slots in the light assembly with
the three screws in the switch housing mounting plate and
turn counterclockwise to align the keyhole slots with the
three screws as shown.
Step 11d. Securely tighten all three screws by hand only
using the provided screwdriver.
Lightbulb Installation
Step 12. Screw in two 60-watt type B-10 Candelabra-base
lightbulbs.
When replacing lightbulbs, be sure to use only 60-watt
maximum.
Installing the Light Assembly Cover Plate
Step 13a. Slide the light assembly cover plate over the
threaded rod as shown.
Step 13b. Twist the light assembly fi nial onto the threaded
rod and tighten securely.
9