1. Manuals
  2. Brands
  3. Casablanca Manuals
  4. Fan
  5. General
  6. Owner's manual

Casablanca General Owner's Manual

Casablanca general ceiling fans: owners manual
Hide thumbs
Table of Contents

Advertisement

Quick Links

O
'
M
WNER
S
ANUAL
GENERAL

Advertisement

Table of Contents
loading

Related Manuals for Casablanca General

Summary of Contents for Casablanca General

  • Page 1 ’ WNER ANUAL GENERAL...

  • Page 3: Table Of Contents

    • This fan is designed to be installed on an existing electrical outlet box. The outlet box must be UL Listed for ceiling fan installations, if it is not, a new box must be installed. Casablanca extension poles are available for sloped or high ceiling installations.

  • Page 4: Mounting Recommendations

    MOUNTING RECOMMENDATIONS Before mounting your Casablanca fan, read the following helpful recommendations. The location of the fan, air circulation, and fan size are all important factors to consider before installation. Location Ceiling fans have practical uses in almost every room in your home. We suggest you follow these mounting recommendations as you decide where to install your Casablanca fan.
  • Page 5 Installing a New Ceiling Fixture Outlet Box If you do not have an existing fixture located where you wish to place your Casablanca fan, an approved ceiling fixture outlet box must be installed and wired. Warning: To reduce the risk of fire, electrical shock,...

  • Page 6: Crossbar Mounting Bracket Installation

    CROSSBAR MOUNTING BRACKET INSTALLATION NOTE: FOR INSTALLATION OUTSIDE USA (EXCEPT MODELS ENDING IN ‘E’) USE THE HANGING INSTRUCTIONS ON PAGE 8. Proceed with installation as follows: Step 1. Route the wires from the ceiling outlet box through the crossbar mounting bracket center hole. Attach the bracket, with ground wire and ridges down, to the ceiling fixture out- let box with the mounting hardware included with the outlet box.

  • Page 7: Hanging The Fan

    Step 3. To hang the fan body in the canopy, hold the fan body firmly and in- sert the ball into the canopy opening. Check that no wires were pinched. Ro- tate the fan body until the slot in the nylon ball fits into the pin opposite the canopy opening.
  • Page 8 BEFORE INSTALLING THE BLADE HOLDERS & BLADES Step 8. Check your fan and identify if it is a Direct Drive or XLP Motor. BLADE BLADE HOLDER SWITCH HOUSING Direct Drive Blade holders attach directly to the motor unit. COMMODORE STYLE CENTER STYLE BLADE HOLDER SCREW BLADE SCREW...
  • Page 9 CENTER STYLE BLADE HOLDER & BLADE Step 8b. Center Style Attach the blades to the blade holders with the four blade screws and steel washers provided for each blade. Hand tighten securely. Install the assembled blade and blade holder to the fly- wheel (round holes) or direct drive motor.

  • Page 10: Fan Installation

    FAN INSTALLATION OUTSIDE THE USA - EXCLUDING MODELS ENDING IN ‘E’ If you do not have an existing fixture located where you wish to place your Casablanca fan, a new ceiling fixture outlet box must be installed (use an outlet box marked acceptable for fan support) and an electrical cable to run it. This box must be secured to the ceiling according to the outlet box manufacturer’s instructions.

  • Page 11: Canopy Installation

    Step 5. Attach the canopy to the crossbar mounting bracket behind the installed outlet adaptor plate with three of the 8-32 x 2 screws and lock washers provided with your Casablanca fan. Hand tighten until snug against the ceiling. Note: On sloped ceilings, align the canopy opening toward the top or peak of the room.
  • Page 12 3-SPEED 3-SPEED • The W-4 allows the choice of four (4) different speed settings. • No light fixture is used. • Set the FAN pull chain switch to the HIGH speed setting. • No changes in household or fan wiring are required.

  • Page 13: 3-Speed Operation

    Pull-chain switches on the fan control the fan and lights. Using the fan control pull-chain switch: Fan off at start. First pull: fan ON, low speed Second pull: medium speed Third pull: high speed Fourth pull: fan OFF Using the optional light pull-chain switch: Light off at start. First pull: light ON Second pull: light OFF Direction of blade rotation is controlled by the reverse slide...
  • Page 14 For this reason the following precautions must be observed: 1. Use only the Casablanca W-32 wall control. 2. Do not use any additional control with your Inteli-Touch fan (for example, dimmer, fan speed control, etc.).

  • Page 15: Inteli•Touch Operation

    INTELI•TOUCH OPERATION button is normally left in the on position. Always turn the power off during cleaning or servicing the fan and during thunderstorms. It is also used to exit or enter additional programs. POWER must be left on to retain a previously set fan speed or light level. INTELI•TOUCH OPERATION There are six individual speed settings for the fan;...
  • Page 16 INTELI•TOUCH OPERATION The Light-Minder program automatically turns OFF the fan mounted lights after two hours. To enter the Light-Minder Program: 1. Turn the OFF for at least three seconds. 2. Turn the 3. Immediately operate the buttons in the following sequence: 4.
  • Page 17 Twist a coin to unsnap the door A. Lift door away from control B and remove C. Changes or modifications not expressly ap- proved in writing by Casablanca Fan Co. may void the user’s authority to operate this equipment. INSTALLATION DRYWALL...

  • Page 18: Versa•Touch Operation

    Fan Control To start the fan. Press the selected speed button to run the fan at the desired speed. Low speed Medium speed High speed To turn off the fan. Press the FAN OFF Airflow Direction To reverse the airflow press the REVERSE button. Reverse operates at any speed whether fan is on or off.
  • Page 19 CAUTION! DO NOT MOUNT REMOTE CONTROL ON OR NEAR A METAL SURFACE - ERRATIC OPERATION WILL OCCUR. Changes or modifications not expressly approved in writing by Casablanca Fan Co. may void the user’s authority to oper- ate this equipment. •••...

  • Page 20: Fan Operation

    General: Your Comfort•Touch remote control uses one of 15 different radio signals to control the fan. This channel is set at the factory. There may be times when the channel needs to be changed,i.e.:...
  • Page 21 Pressing the button will change the direction of rotation. An audio tone signals the beginning of the reverse sequence and you will see the airflow direction arrow changing. The fan gradually slows to a stop, then reverses direction. Note: This function does not operate if the fan is not running. In the Auto Speed mode, fan speed changes in response to changes in room tempera- ture.
  • Page 22 COMFORT•TOUCH Changing the control channel 1. Hold the button down until a tone is heard. 2. The temperature display will show the current channel number. 3. Press fan up or down buttons to change the number to a unique number from 49 to 63. DO NOT use other channel numbers.

  • Page 23: Troubleshooting

    TENT: Check AC supply for irregularities, (noise spikes, fluctuations, or failure); or circuit board assembly. TROUBLESHOOTING Never Lubricate this Fan! The precision motor at the heart of your Casablanca fan features sealed bearings that are lubricated for life. Do not attempt to oil the motor.
  • Page 24 PROBLEM PROBLEM FAN WILL NOT START Check main circuit fuses, circuit breakers, or wall switch position. Check all wire connections, making sure the power is turned off during this inspection. Pin connectors are not making good contact. Release lockpin and check pins at end of downrod & inside coupler and also 9 pin connector under cover.
  • Page 25 RINTED IN...

Table of Contents