Table of Contents
Advertisement
Fan Control
To start the fan. Press the selected speed button to run the fan at the desired speed.
LOW=Low speed MED=Medium speed
To turn off the fan, press the FAN OFF button.
Airfl ow Direction
To reverse the airfl ow, press the REVERSE button. REVERSE operates at any speed
whether the fan is on or off . Th e fan returns to its set speed after reversing.
Light Control
Turn the light on or off independently from the fan by pressing the LIGHT rocker switch.
(Press the left side for the uplight, right side for the downlight, and the middle for both.)
If you press the button for more than 0.7 seconds, it becomes a dimmer. Th e light varies
from "bright" to "dim" over approximately 8 seconds. If you continue to hold the LIGHT
button, this sequence will reverse when the light reaches its brightest or dimmest level.
Release the button when the desired level is reached.
Auto Resume
Quick (pressing less than 0.7 seconds) on/off operation of the LIGHT button maintains
the desired brightness level set previously.
CHANGING TRANSMITTER FREQUENCY SETTING
Note: All fans leave the factory set to "00000."
You will only have to change the dip switch settings in the remote
if you are using more than one fan in the same area and want to
control them separately.
Step 1. At the circuit breaker or fuse box, turn the power off for
the fan you want to change.
Step 2. Open the battery door of the Versa•Touch control and
remove the batteries.
Step 3. Change the dip switch settings, assuring that they are
diff erent from the previously installed Versa•Touch fan.
Step 4. Reinstall the batteries and the battery door on the
control.
Step 5. At the circuit breaker or fuse box, turn the power back on
for the fan whose frequency you are changing.
Note: You may want to label your controls to assure you do not
mix them up.
If the fan is not functioning after installation:
Step 1. Check to make sure the batteries are installed correctly
in the control.
Step 2. Turn the power off to the fan (from the circuit breaker)
for at least 5 seconds.
Step 3. Turn the power back on (at the circuit breaker) and push
the HIGH, MED, and LOW buttons–in that order–within 20
seconds. Th e fan should now function properly.
REMOTE OPERATION
HIGH=High speed
R
EVERIE
Send Signal
LED
UP-
MED
LOW
REVERSE
Dip Switch
set to "10000"
set to "01001"
WARNING!
Do not turn the power off at the circuit breaker, then
back on, for the previously installed Versa•Touch2
fan(s), as you may inadvertently change the
frequency settings for it as well.
Press in this order to set new
Circuit Breaker
1. HIGH
or Fuse Box
™
DOWNLIGHT
HIGH
FAN
OFF
Versa•Touch 2
Control
(back)
Dip Switch
2
3
1
frequency:
2. MED
3. LOW
13
Advertisement
Table of Contents
