User Safety Summary - Xerox Phaser 840 Service Manual

User safety summary

Terms in manual
CAUTION
WARNING
Power source: For 110 VAC printers, do not apply more than 130 volts RMS between
the supply conductors or between either supply conductor and ground. Use only the
specified power cord and connector. For 220 VAC printers, do not apply more than 250
volts RMS between the supply conductors or between either supply conductor and ground.
Use only the specified power cord and connector. Refer to a qualified service technician
for changes to the cord or connector.
Operation of product: Avoid electric shock by contacting a qualified service
technician to replace fuses inside the product. Do not operate without the covers and
panels properly installed. Do not operate in an atmosphere of explosive gases.
WARNING
Safety instructions: Read all installation instructions carefully before you plug the
product into a power source.
Terms on product
CAUTION
DANGER
Care of product: Disconnect the power plug by pulling the plug, not the cord.
Disconnect the power plug if the power cord or plug is frayed or otherwise damaged, if
you spill anything into the case, if product is exposed to any excess moisture, if product is
dropped or damaged, if you suspect that the product needs servicing or repair, and
whenever you clean the product.
Ground the product: Plug the three-wire power cord (with grounding prong) into
grounded AC outlets only. If necessary, contact a licensed electrician to install a properly
grounded outlet.
Symbols as marked on product:
Conditions that can result in damage to the product.
Conditions that can result in personal injury or loss of life.
Turning the power off using the On/Off switch does not de-energize
the printer. You must remove the power cord to disconnect the
printer from the mains. Keep the power cord accessible for removal
in case of an emergency.
A personal injury hazard exists that may not be apparent. For
example, a panel may cover the hazardous area. Also applies to a
hazard to property including the product itself.
A personal injury hazard exists in the area where you see the sign.