Xerox Phaser 840 Service Manual page 163

Install the adjustment tension spring by hooking one end through the backside of the
7.
tilt arm, stretching the spring and hooking the other through the hole in the printer
frame bracket.
Due to the spring force, stand in front of the printer to hold it in
Note
place while you pull the spring toward you to install it.
Hook through
inside of tilt
arm
Adjustment
tension
spring
Fig 4-6 Adjusting the tension spring
Grasp
spring at
this point
Hook other end of
spring through
frame bracket
Diagnostics and Adjustments
0388-86
4 - 147