Y-axis belt drive assembly (Phaser 840 printer)
Remove the right cover.
1.
Disconnect the wiring harness leading from the front panel to the right
2.
I/O board passing beside the Y-axis belt drive assembly.
Remove the drum fan. (Note the fan orientation, it blows into the drum.)
3.
Never loosen or remove the three screws securing the assembly
Caution
parts together.
Remove the three tension set screws securing the Y-axis belt drive assembly to the
4.
engine frame. Remove the assembly with its two belts
Reverse these steps to reinstall the Y-axis drive assembly.
5.
Tension the belts using the "Y-axis belt tension adjustment (Phaser 840 printer)", on
6.
page 4-142.
Fig 7-18 Removing the Y-axis belt drive assembly
(Phaser 840 printer)
7 - 200
Phaser 840/850/860/8200 Color Printer - Service Manual
Y-axis belt
assembly
Never
remove
these
screws
Mounting
screws
840-4-12