Xerox Phaser 840 Service Manual page 75

Table 2-5 22,LSS.TC Error Codes: Media Jams
22,LSS.TC: Media jams
L indicates the location of
the jam
1. Bottom Hi-capacity
Paper Feeder
2. Middle Hi-capacity
Paper Feeder
3. Top standard tray
4. Handfeed
5. Front cover
6. Top cover
7. Y-axis jams
(see following error codes)
8. Door opened jams
(see following error codes)
T indicates whether a timeout or an event occurred
0 = event. An unexpected event occurred
1 = timeout. Time expired without the expected event occurring
C indicates checksum
Refer to the fault history when troubleshooting media jams, this offers the quickest and easiest
method of troubleshooting.
For the Phaser 840 printer:
1. Pull the paper tray out about 1 inch (2.5 cms.). This activates all three tray sensors.
2. Hold down the left arrow and press "?" (the help button). This displays the fault history menu
with the most recent code at the top.
For the Phaser 850 printer:
1. Hold down the left arrow and press "?" (the help button). This displays the fault history menu
with the most recent code at the top.
For the Phaser 860 printer:
1. Hold down the Scroll Up button and press OK.
SS indicates sensor location:
00 Usually because of an opened door
01 Bottom High-Capacity tray sensors
02 Bottom High-Capacity pick sensors
03 Middle High-Capacity tray sensors
04 Middle High-Capacity pick sensors
05 Standard-tray sensors
06 Standard-tray pick sensors
07 Handfeed sensors
08 Preheat-entry sensor
09 Stripper Sensor not activated
10 A and A4 width sensors
11 A and A4 width sensor
12 Preheat exit sensor
13 Stripper exit sensor
14 Duplex entry sensor
15 Media Exit Sensor
16 VE_DM CYCLE_DONE out of order
17 VE_TF_ROLLER_LIFTED out of order
18 Duplex length measured to be too long
19 Timing delay affected transfix staging
20 Media not visible in top cover (not used)
21 High-Capacity media length too long (not used)
22 Unknown reason
Error Codes and Messages 2 - 59