Phaser 840/850 Ram And Printer Capabilities - Xerox Phaser 840 Service Manual

Phaser 840/850 RAM and Printer Capabilities

The Phaser 840 printer features two DIMM connectors which accept both 32- or
64-Mbytes RAM DIMMs (16-Mbyte RAM DIMMs work but are not offered). The
Phaser 850 printer features two DIMM connectors which will accept both 64- or
128-Mbytes RAM DIMMs. The printers can use SDRAM DIMMs meeting these
specifications:
168-pin DIMM
I
Synchronous DRAM
I
3.3 volts
I
10 nsec speed
I
Valid on-board Serial Presence Detect ROM
I
Unbuffered
I
Latency of 2
I
9 address columns (Phaser 850 printer allows 32-Mbytes DIMM to be in 8
I
columns)
Maximum of 2.8 cm (1.1 in.) in height (Phaser 840 printer only). SDRAM
I
DIMMs from other Phaser printers, such as the Phaser 740 and Phaser 780
color printers may be too tall to fit inside a Phaser 840 printer.
Upon power-up, the image processor interrogates the 256-byte Serial Presence Detect
EEPROM, which describes the DIMM in great detail, such as data width, clock delay,
number of address columns and row, refresh rate and more. If the DIMM does not meet
the required specifications, it will be ignored; no error message will be reported.
General Information 1 - 7