Paper/Drum Heater - Xerox Phaser 840 Service Manual

Paper/drum heater

Disconnect the power cord. AC voltages may be present at the
Warning
heaters, even with the printer turned off.
Turn off the printer and remove the power cord.
1.
Remove the right cover.
2.
Remove the left cover.
3.
Remove the upper feed roller as described in the topic "Upper feed roller assembly",
4.
on page 7-185.
Disconnect the locking wiring harness from the right side of the paper/drum heater.
5.
At the front of the paper/drum heater remove the two screws securing the heater to the
6.
inside of the printer frame. Do not confuse the mounting screws with the nearby
smaller, brass-colored assembly screws.
Paper / Drum
heater
Fig 7-8 Removing the paper/drum heater
Removal and Replacement Procedures
Wiring
harness
840-4-16
7 - 187