User Safety Summary - Xerox Phaser 8400 Service Manual

User Safety Summary

Terms in manual
Caution
Conditions that can result in damage to the product.
Warning
Conditions that can result in personal injury or loss of life.
Power source: For 110 VAC printers, do not apply more than 130 volts RMS
between the supply conductors or between either supply conductor and ground. Use
only the specified power cord and connector. For 220 VAC printers, do not apply
more than 250 volts RMS between the supply conductors or between either supply
conductor and ground. Use only the specified power cord and connector. Refer to a
qualified service technician for changes to the cord or connector.
Operation of product: Avoid electric shock by contacting a qualified service
technician to replace fuses inside the product. Do not operate without the covers and
panels properly installed. Do not operate in an atmosphere of explosive gases.
Warning
Turning the power off using the On/Off switch does not de-energize the
printer. You must remove the power cord to disconnect the printer from the
mains. Keep the power cord accessible for removal in case of an emergency.
Safety instructions: Read all installation instructions carefully before you plug the
product into a power source.
Terms on product
Warning
A personal injury hazard exists that may not be apparent. For example, a
panel may cover the hazardous area. Also applies to a hazard to property
including the product itself.
Warning
Personal injury hazard exists in the area where you see the sign.
Care of product: Disconnect the power plug by pulling the plug, not the cord.
Disconnect the power plug if the power cord or plug is frayed or otherwise damaged,
if you spill anything into the case, if product is exposed to any excess moisture, if
product is dropped or damaged, if you suspect that the product needs servicing or
repair, and whenever you clean the product.
Service Manual i