Power Supply; Removing The Power Supply - Xerox Phaser 840 Service Manual

Power supply

Even when the printer is off, AC line voltages may be present at
Warning
the printer heaters while the printer is plugged into AC power.
Turn off the printer and remove the power cord.
1.
Remove the right cover.
2.
Remove the left cover.
3.
Remove the rear cover.
4.
Remove the top cover.
5.
At the right side of the printer, disconnect the two wiring harnesses leading to the
6.
power supply.
Remove the four screws securing the power supply in place. Remove the power
7.
supply.
Power supply
Fig 7-4 Removing the power supply
Wiring
harnesses
Removal and Replacement Procedures
840-4-32
7 - 183