Setting The Panel's Device Number; Wireless Settings - Wireless Access Overview; Dhcp - AMX Modero ViewPoint MVP-5200i Operation/Reference Manual

FIG. 18 Protected Setup page
The default password for the Protected Setup page is 1988, but this may be changed
at any time.
For more information on the Setup and Protected Setup pages, refer to the Setup Pages section on page 41 and
the Protected Setup Pages section on page 53.

Setting the Panel's Device Number

In the Protected Setup page:
1.
Press the Device Number field in the Device ID section to open the Device Number keypad.
2.
The Master will assign the panel a new Device ID once connected. The default Device number is 0.
3.
Press Done to return to the Protected Setup page.
4.
Press Reboot to reboot the device and apply the new Device Number.

Wireless Settings - Wireless Access Overview

DHCP

When choosing DHCP, a DHCP server must be accessible before the fields are populated.
If the SSID (Network Name) and WEP fields have not previously been configured, the
Wireless Settings page will not work until the panel is rebooted.
MVP touch panels connect to a wireless network through their use of the pre-installed AMX 802.11g wireless
interface card. This allows users to communicate with an Access Point (AP). The AP communication
parameters must match those of the pre-installed wireless interface card installed within the panel. This
internal card transmits data using 802.11x signals at 2.4 GHz. For a more detailed explanation of the security
and encryption technology, refer to the Appendix B: Wireless Technology section on page 180.
For more information on utilizing the AMX Certificate Upload Utility in conjunction with the EAP security,
refer to the AMX Certificate Upload Utility section on page 187.
MVP-5200i Modero® ViewPoint® Touch Panel with Intercom, 5.2 and 5"
Configuring Communication
21