Configuring Modero Firmware Via The Usb Port; Prepare Netlinx Studio For Communication Via The Usb Port - AMX Modero ViewPoint MVP-5200i Operation/Reference Manual

Appendix B: Wireless Technology

Configuring Modero Firmware via the USB Port

The MVP-5200i needs to be configured to connect with a PC to transfer firmware via the mini-USB port. To
configure the touch panel:

Prepare NetLinx Studio For Communication Via the USB Port

1.
From the Start menu in Windows XP, open the Network Connections dialog (Start > Settings >
Network Connections > Local Area Connection).
2.
Look for the Local Area Connection reading Local Area Connection, AMX USB Device Link and double-
click on it to open the Local Status.
3.
Press the Properties tab to open the Local Area Connection Properties section.
4.
Press the Properties button to open the TCP/IP Properties dialog box.
5.
Set the IP address to an address within the same subnet as the panel IP address specified within the USB
IP settings of the panel. For instance, if the default IP address on the device is 12.0.0.2, set the IP address
to 172.16.0.2.
6.
Set the Subnet Mask to 255.255.255.0.
7.
In the TCP/IP Properties dialog box, click OK.
8.
In the Local Area Connection Properties, section, click Close.
174 MVP-5200i Modero® ViewPoint® Touch Panel with Intercom, 5.2 and 5"