Using G4 Web Control To Interact With A G4 Panel - AMX Modero ViewPoint MVP-5200i Operation/Reference Manual

Configuring Communication
18.
Press the Back button to return to the Protected Setup page, and Exit to return to the Setup page.
19.
The USB connection will be signified by the WiFi/Wired/USB icon changing into a USB icon (FIG. 39).
FIG. 39 USB icon

Using G4 Web Control to Interact with a G4 Panel

The G4 Web Control feature allows you to use a PC to interact with a G4-enabled panel via the Web. This
feature works in tandem with the new browser-capable NetLinx Security firmware update (build 300 or
higher). G4 Web Control is only available with the latest Modero panel firmware.
Refer to the G4 Web Control Settings Page section on page 76 for more detailed field information.
Verify your NetLinx Master (ME260/64 or NI-Series) has been installed with the latest
firmware KIT file from www.amx.com. Refer to the NetLinx Master instruction
manual for more detailed information on the use of the new Web-based NetLinx
Security.
1.
Press and hold the two lower buttons on both sides of the display for 3 seconds to open the Setup page.
2.
Press the Protected Setup button (located on the lower-left of the panel page) to open the Protected Setup
page and display an on-screen keypad.
3.
Enter the appropriate password into the Keypad's password field (1988 is the default password with a new
unit) and press Done.
4.
Press the G4 WebControl button to open the G4 Web Control Settings page (FIG. 40).
FIG. 40 G4 Web Control page
36 MVP-5200i Modero® ViewPoint® Touch Panel with Intercom, 5.2 and 5"