Right-Side Components - Arctic Cat DVX 400 2006 Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
3. Remove the starter driven gear (2), two align-
ment pins (3), and the cover gasket (4). Account
for two thrust washers from the driven gear.
NOTE: If the right-side components are to be
removed, do not remove the rotor/flywheel. Pro-
ceed to step 7.
4. Using a 27 mm offset box-end wrench, hold the
rotor/flywheel; then remove the nut securing the
rotor/flywheel to the crankshaft.
5. Using an appropriate magneto rotor remover,
remove the rotor/flywheel assembly from the
crankshaft.
6. Remove the key (3); then remove the starter
driven gear (4).
www.mymowerparts.com
Back
3-8
SP152
SP153
SP154
Back to TOC
7. Remove the Allen-head cap screws securing the
neutral switch housing (1); then remove the
switch. Account for one O-ring (2), two switch
contacts (3 and 4), and the two springs behind
the switch contacts.
NOTE: To aid in installing, it is recommended
that the assemblies be kept together and IN
ORDER.

Right-Side Components

NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
AT THIS POINT
To service any one specific component, only
limited disassembly of components may be
necessary. Note the AT THIS POINT information in
each sub-section.
NOTE: The engine/transmission does not have
to be removed from the frame for this procedure.
Back to Section TOC
SP175A
Next