Coolant; Www.mymowerparts.com; Drive Chain - Arctic Cat DVX 400 2006 Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983

Coolant

The cooling system capacity is approximately 1.2 L
(1.3 U.S. qt). The cooling system should be
inspected daily for leakage and damage. Also, the
coolant level should be checked periodically.
When filling the cooling system, use premixed Arc-
tic Cat Antifreeze (p/n 0638-395). While the cooling
system is being filled, air pockets may develop;
therefore, run the engine for five minutes after the
initial fill, shut the engine off, and then fill the cool-
ing system to the bottom of the stand pipe in the
radiator neck (1). Make sure the coolant level in the
overflow tank is between the upper and lower
marks.
! CAUTION
After operating the ATV for the initial 5-10
minutes, stop the engine, allow the engine to cool
down, and check the coolant level. Add coolant as
necessary.

www.mymowerparts.com

Back
SP131
SP019
Back to TOC

Drive Chain

INSPECTING
To properly check the drive chain for defects, sup-
port the ATV with a jack or suitable block under the
swing arm allowing the rear wheels to turn freely.
With the transmission in neutral, slowly rotate the
wheels and inspect the drive chain for the following
items:
1. Loose Pins
2. Damaged Rollers
3. Dry or Rusted Links
4. Kinked or Binding Links
5. Excessive Wear
6. Improper Adjustment
7. Missing O-Ring Seals
MEASURING
1. Loosen the four cap screws on top of the swing
arm; then turn the adjuster nut clockwise until
all slack is out of the chain.
2. Count out 21 pins on the chain and measure the
distance between the two points. If this distance
exceeds the service limit of 319.4 mm (12.57
in.), the chain must be replaced.
Back to Section TOC
2
SP061A
Next
2-23