Arctic Cat DVX 400 2006 Manual page 128

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
3. Apply multipurpose grease to the lip of the dust
covers; then install the dust covers (1), washers
(2), and spacers (3) to the swing arm.
4. Using a suitable bearing installer, install the new
rear arm bearings to the specified depth; then
install the dust seals coating the seal lips and
bearings with multipurpose grease. See the illus-
tration below for the proper bearing depths.
www.mymowerparts.com
Back
SP358A
SP360
ATV2195
Back to TOC
NOTE: The stamped mark of the dust seals must
be directed towad the outside of the assemblies.
5. Install the swing arm and pivot shaft; then install
the swing-arm pivot nut and tighten to specifica-
tions.
6. Install the rear shock absorber and front arm;
then tighten the shock absorber mounting nuts
(1 and 2) to specifications.
7. Install the rear arm bolts and nuts; then tighten
the nuts (3 and 4) to specifications.
Back to Section TOC
SP361
SP362
7
SP363A
Next
7-11