Preparation After Storage - Arctic Cat DVX 400 2006 Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
7. Tighten all nuts, bolts, cap screws, and screws.
Make sure rivets holding components together
are tight. Replace all loose rivets. Care must be
taken that all calibrated nuts, cap screws, and
bolts are tightened to specifications.
8. Fill the cooling system to the upper level line on
the overflow tank with properly mixed coolant.
9. Disconnect the battery cables; then remove the
battery, clean the battery posts and cables, and
store in a clean, dry area.
! CAUTION
This maintenance-free battery should be charged at
the recommended rate every 30 days or permanent
damage will result if the battery completely dis-
charges.
10. Store the ATV indoors in a level position.
! CAUTION
Avoid storing outside in direct sunlight and avoid
using a plastic cover as moisture will collect on the
ATV causing rusting.
Preparation After
Storage
Taking the ATV out of storage and correctly prepar-
ing it will assure many miles and hours of trouble-
free riding. Arctic Cat recommends the following
procedure to prepare the ATV.
1. Clean the ATV thoroughly.
2. Clean the engine. Remove the cloth from the
exhaust system.
www.mymowerparts.com
Back
Back to TOC
3. Check all control wires and cables for signs of
wear or fraying. Replace if necessary.
4. Change the engine/transmission oil and filter.
5. Check the coolant level and add properly mixed
coolant as necessary.
6. Charge the battery; then install. Connect the bat-
tery cables.
! CAUTION
This maintenance-free battery should be charged at
the recommended rate every 30 days or permanent
damage will result if the battery completely dis-
charges.
7. Check the entire brake systems (fluid level,
pads, etc.), all controls, headlights, taillight,
brakelight, and headlight aim; adjust or replace
as necessary.
8. Tighten all nuts, bolts, cap screws, and screws
making sure all calibrated nuts, cap screws, and
bolts are tightened to specifications.
9. Check tire pressure. Inflate to recommended
pressure as necessary.
10. Make sure the steering moves freely and does
not bind.
11. Check the spark plug. Clean or replace as neces-
sary.
12. Follow the recommendations found in the pre-
start inspection.
13. Inspect the drive chain and sprockets. Adjust or
replace as necessary.
Back to Section TOC
1
1-5