Arctic Cat DVX 400 2006 Manual page 31

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
ADJUSTING
To adjust the drive chain, use the following proce-
dure.
1. Loosen the four cap screws on the top of the
swing arm; then turn the adjuster nut until the
chain has 30-40 mm (1.2-1.6 in.) slack midway
between the chain buffer and the rear sprocket.
www.mymowerparts.com
Back
2-24
ATV2156
SP061A
SP061B
Back to TOC
2. Tighten the four cap screws to specifications
(see Section 10) and recheck the chain tension.
REPLACING
NOTE: When replacing the drive chain, replace
the chain and sprockets as a set.
1. Place the ATV on a level surface and block the
front wheels; then raise the rear end and place
support under the axle housing.
2. Remove the left-rear wheel; then remove the
cotter pin, hub nut, flat washer, and the hub.
3. Loosen the four cap screws on top of the swing
arm; then slacken the chain by turning the
adjuster nut counterclockwise.
Back to Section TOC
ATV2157
SP061A
Next