Arctic Cat DVX 400 2006 Manual page 32

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
4. Locate and remove the master link (chain con-
nector link); then remove the drive chain.
5. Remove the four cap screws securing the driven
sprocket to the sprocket hub; then remove the
sprocket from the axle.
6. Remove the two cap screws securing the drive
sprocket cover; then remove the cover.
7. Remove the drive sprocket cap screws and
remove the sprocket.
8. Install a new drive sprocket; then apply red Loc-
tite #271 to the drive sprocket cap screws and
tighten to specifications (see Section 10).
www.mymowerparts.com
Back
SP061B
SP134
Back to TOC
9. Install a new driven sprocket; then apply red
Loctite #271 to the sprocket mounting cap
screws and tighten to specifications (see Section
10).
10. Install a new chain and adjust (see Adjusting in
this sub-section).
11. Install the drive sprocket cover and tighten
securely.
12. Lightly lubricate the axle spline with multipur-
pose grease; then install the hub, flat washer,
and the hub nut and tighten to specifications (see
Section 10).
13. Install a new cotter pin; then install the wheel
and tighten the lug nuts to specifications (see
Section 10) using a crisscross pattern.
Back to Section TOC
2
SP136
SP018A
2-25