Setup Mode Overviews - Intermec EasyCoder 501 E Installation & Operation Manual

Chapter 8 Setup Mode
Setup Mode Overview, Part 1
SETUP: min CONTRAST max
CONTRAST
SETUP: SER-COM:
SER-COM UART1
UART2
UART3
If an optional interface board
with at least one serial channel
is fitted, communication setup
menus for each of the channels
will be displayed.
SETUP: DETECTION:
DETECTION LSS ADJUST
DETECTION:
FEEDADJ
SETUP:
SERVICE
74
• Press F4 to decrease 1 step
• Press F5 to increase 1 step
SER-COM: BAUDRATE:
BAUDRATE 9600
19200
38400
300
600
SER-COM: PARITY:
PARITY NONE
EVEN
ODD
MARK
SPACE
SER-COM: CHAR LENGTH:
CHAR LENGTH 7
8
SER-COM: STOP BITS:
STOP BITS 2
1
SER-COM: FLOWCONTROL:
FLOWCONTROL RTS/CTS
FLOWCONTROL:
ENQ/ACK
FLOWCONTROL:
XON/XOFF
FLOWCONTROL:
PROT ADDR
SER-COM: NEW LINE:
NEW LINE CR/LF
LF
Ent er
CR
LABEL <> GAP
FEEDADJ: STARTADJ:
STARTADJ [0]:
FEEDADJ: STOPADJ:
STOPADJ [0]:
Ent er
Intermec EasyCoder 501 E – Installation & Operation Ed. 1
Intermec Fingerprint v6.14
LEGEND:
Boxes with thick lines indicate default setup
Boxes with dotted lines indicate menus related to
optional interface boards.
Baudrate 38,400 is only
available on "uart2:" and "uart3:"
1200
2400
4800
RTS/CTS:
DISABLE
ENABLE
ENQ/ACK:
DISABLE
ENABLE
XON/XOFF:
DATA FROM HOST
XON/XOFF:
DATA TO HOST
PROT ADDR:
DISABLE
ENABLE
• Press F1 to view current value
• Press F2 to decrease value 1 step
• Press F3 to increase value 1 step
• Press F4 to decrease value 10 steps
• Press F5 to increase value 10 steps
• Press Feedto autoadjust the LSS and
feed out one label.
• Press Enter to enter the Service part (see next page).
• Press F5 to go back to the "Setup; Contrast" menu.
• Press Setup to exit the Setup Mode.
Not for RS422/485
on "uart2:"
DATA FROM HOST:
ENABLE
DISABLE
DATA TO HOST:
ENABLE
DISABLE
Only for RS422/485
on "uart2:"