Intermec EasyCoder 501 E Installation & Operation Manual page 39

Chapter 5 Media Load
Peel-Off, cont.
6b
In case of a label roll with a 76.2 mm (3
inches) core, fi rst fi t the adapter on the media
supply hub.
8
Route the media under the guide plate of the
label stop sensor and push it inwards towards
the center section as far as it will go.
38
7
Pull out the media and route it under the slack
absorber and through the print unit as illus-
trated. Then push the roll inward on the hub.
9
This diagram shows the path of the labels and
Intermec EasyCoder 501 E – Installation & Operation Ed. 1
the liner.