Cpu Board; Accessing The Cpu Board - Intermec EasyCoder 501 E Installation & Operation Manual

Appendix 3

CPU Board

Accessing the
CPU Board
WARNING!
Disconnect the power cord
before removing the cover.
Dangerous voltage!
Cover Plate
4 Screws
134
The CPU board is situated in the electronics compartment on the left
side of the printer's center section. To gain access to the electronics
compartment, proceed as follows:
• Switch off the printer and disconnect the power cord. The
CPU board contains power supply circuits with dangerous
voltage.
• Remove the four #T10 Torx screws situated along the lower edge of
the cover plate as indicated on the illustration below.
• Open the right-hand door and remove the four #T10 Torx screws
at the top of the cover plate.
• Remove the cover plate.
• Reassemble in reverse order.
Intermec EasyCoder 501 E – Installation & Operation Ed. 1
4 Screws