Intermec Shell Startup Program Introduction - Intermec EasyCoder 501 E Installation & Operation Manual

Chapter 9
Intermec Shell Startup Program
Introduction
76
Intermec Shell is a startup program (also called "autoexec-fi le"),
which is a program that automatically starts running when the printer
is switched on. Intermec Shell helps the operator to choose between
a number of standard or custom-made application programs and to
start certain useful facilities, as listed below.
Application Programs
• Intermec LabelShop
• Intermec Windows Driver
• Intermec Fingerprint
• Intermec Direct Protocol
• LINE_AXP.PRG
• Other application programs in the printer's memory
A prerequisite is that the program is provided with the extension
".PRG". However, some original Intermec utility programs are
excluded as long as they remain stored in "rom:":
- ERRHAND.PRG
- ERRH910.PRG
- FILELIST.PRG
- MKAUTO.PRG
- TEST910.PRG
Other Facilities
• Terminal Setup (remote setup and Shell control)
• Setup Mode (manual setup from printer's keyboard)
• Print Setup (printing setup on label)
• Testfeed (formfeeds + auto-adjust of the LSS)
• Test Label (printing of test labels)
• Font Scaling (only if optional Scaleable Fonts Kit is installed)
• Ser-Com Reset (resetting all setup parameters to default)
• Clear RAM (erasing the printer's RAM memory)
• Reboot (restarting the printer)
Intermec EasyCoder 501 E – Installation & Operation Ed. 1
(WYSIWYG label design program)
(do not use)
(for creating your own programs or to
run the Intermec InterDriver)
(easy-to-use slave protocol)
(line analyzer program)
.
.