Configuring Startup Network Settings; Configuring Security On The Cisco Unified Ip Phone - Cisco 7962G Administration Manual

Chapter 3 Setting Up the Cisco Unified IP Phone
4.
5.
6.
If the phone successfully passes through these stages, it has started up properly. If the phone does not
start up properly, see the

Configuring Startup Network Settings

If you are not using DHCP in your network, you must configure these network settings on the
Cisco Unified IP Phone after installing the phone on the network:
•
•
•
•
•
Collect this information and see the instructions in
Unified IP Phone."

Configuring Security on the Cisco Unified IP Phone

The security features protect against several threats, including threats to the identity of the phone and to
data. These features establish and maintain authenticated communication streams between the phone and
the Cisco Unified Communications Manager server, and digitally sign files before they are delivered.
For more information about the security features, see the
Unified IP Phones" section on page
Security Guide.
OL-18913-01
Mute—Phone is downloading images from the TFTP server.
–
Speaker—Phone is writing images to its Flash memory.
–
The phone screen displays the Cisco Systems, Inc., logo screen.
These messages appear as the phone starts:
Verifying Load (if the phone load does not match the load on the TFTP server). If this message
–
appears, the phone starts up again and repeats step 1 through step 4 above.
Configuring IP
–
Updating CTL
–
Updating Locale
–
Configuring Unified CM List
–
Registering
–
The phone screen displays:
Current date and time
–
Primary directory number
–
Additional directory numbers and speed dial numbers, if configured
–
– Softkeys
"Resolving Startup Problems" section on page
IP address
IP subnet information (subnet mask for IPv4 and subnet prefix length for IPv6)
Default gateway IP address
TFTP server IP address
You also may configure the domain name and the DNS server settings, if necessary.
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 7.1
Chapter 4, "Configuring Settings on the Cisco
"Understanding Security Features for Cisco
1-11. Also, refer to Cisco Unified Communications Manager
Configuring Startup Network Settings
9-1.
3-13