Cisco 7962G Administration Manual page 101

Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Table 4-15 Media Configuration Menu Options (continued)
Option Description
Recording Tone Local Indicates the loudness setting for the beep tone
Volume that is received by the party whose phone has the
Recording Tone option enabled.
This setting applies for each listening device
(handset, speakerphone, headset).
Range: 0 percent (no tone) to 100 percent (same
level as current volume setting on the phone).
Default: 100
See also: Recording Tone
Recording Tone Indicates the loudness setting for the beep tone
Remote Volume that the remote party receives. The remote party
is the party who is on a call with the party whose
phone has the Recording Tone option enabled.
Range: 0 percent to 100 percent. (0 percent is
-66 dBM and 100 percent is -3 dBM.)
Default: 84 percent (-10dBM)
See also: Recording Tone
Recording Tone Indicates the length of time in milliseconds for
Duration which the beep tone plays.
If the value you configure here is less than one
third the interval, then this value overrides the
default provided by the Network Locale.
Range: 0 to 3000
Note
See also: Recording Tone
Wideband Handset Indicates whether wideband is enabled or
disabled for the handset.
Default: "Use Phone Default" on Cisco Unified
Communications Manager Administration.
(This default means that the phone will be
enabled for a wideband handset only if the
phone was shipped with a wideband handset.)
OL-18913-01
For some Network Locales that use a
complex cadence, this setting applies
only to the first beep tone.
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 7.1
To Change
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
If Wideband Handset UI Control is enabled,
•
you or the user can choose
> User Preferences >
Audio Preferences > Wideband Handset.
• If Wideband Handset UI Control is disabled,
use Cisco Unified Communications Manager
Administration and choose Device > Phone >
Phone Configuration to set this value.
If you allowed this option to be user
Note
controllable (in the Wideband Handset UI
Control option), the user-configured value
takes precedence.
Device Configuration Menu
4-27