Figure 3-19. Removing and Installing the RAID Controller Card
1
RAID controller card
8 If applicable, remove the RAID battery. See "Removing the RAID Battery"
on page 169.
Installing the RAID Controller Card
CAUTION:
card riser. Do not attempt to install expansion cards directly into the riser
connector on the system board.
1 Unpack the RAID controller card and prepare it for installation. For
instructions, see the documentation accompanying the card.
2 Hold the RAID controller card by its edges, position the card so that the
card edge connector aligns with the expansion card riser connector on the
front cover. See Figure 3-19.
3 Insert the card edge connector firmly into the riser connector until the
card is fully seated.
168
Installing System Components
1
Expansion cards can only be installed in the slots on the expansion
2
M3 screw (1)
2