Table of Contents
Advertisement
CHAPTER 2: INSTALLING THE D.20 RIO
Configuring device options
D.20 RIO - HARDWARE USER'S MANUAL
Figure 1: D.20 RIO unit dimensions
8.66 in.
(220 mm)
The following connection options are configured by setting hardware switches and
jumpers on the main board:
•
SW1: D.20 channel 1 to D.20 link port B
•
SW3: D.20 channel 2 to D.20 link port B
•
SW2: End of link termination
•
JP1: Power supply to D.20 connectors
These options should be configured before you permanently mount the device.
The location of these switches and jumpers is shown in "Configuration switches and
jumpers" on page 22.
GE Information
CONFIGURING DEVICE OPTIONS
1.71 in.
(43.5 mm)
5.75 in.
(146 mm)
21
Advertisement
Table of Contents
