GE D.20 RIO Hardware User Manual page 63

APPENDIX A: STANDARDS & PROTECTION
D.20 RIO - HARDWARE USER'S MANUAL
Table 22: Environmental Standards
Standard Name Description
IEC 60068-2-1 Cold
2
IEC 60068-2-2 Dry Heat
IEC 60068-2-6 Vibration (sinusoidal)
IEC 60255-21-1
IEC 60068-2-27 Shock - Operating Response Test
Shock - Non-Operating
Withstand Test
IEC 60068-2-29 Bump – Non operating test
IEC 60068-2-31 Drop and topple
IEC 60068-2-78 Humidity Testing
IEEE 1613, Section 4.1.1 Power Supply Temperature
Testing Operational
IEEE 1613, Section 4.1.1 Power Supply Temperature
Testing Non-operational
Table 23: Communication Standards
Standard Name Description
IEEE 802.3 CSMA/CD Access Method (and
physical layer specifications)
IEC 61850-3 Communication networks and
systems in substation – General
requirements
IEEE 802.3 CSMA/CD Access Method (and
physical layer specifications)
1 To comply, the D.20 RIO Distributed I/O Controller BIOS Spread Spectrum clock setting
must be set to "disable". This is the factory default.
2 To comply, the D.20 RIO Distributed I/O Controller BIOS DRAM clock setting must be set to
"HCLK-33M". This is the factory default.
GE Information
COMPLIANCE STANDARDS
Test Specification
2 hours non powered, soak at
then warm to 20 °C and leave
−
powered for 16 hours
16 hours powered at + 70 °C
A logarithmic sweep from 10 Hz to 150
Hz to 10 Hz at 1 oct/min for 1 sweep
cycle in the 3 orthogonal axes.
Acceleration level 1 g
Pulse shape: Half sine Pulse duration:
11 mS
- Operating Response Test:
Acceleration level: 5 g's
- Non-Operating Withstand Test:
Acceleration level: 15 g's
3 pulses per polarity per axis for a total
of 18 pulses
Pulse shape: Half sine Pulse duration:
11 mS Acceleration level: 10 g's
1000 pulses per polarity per axis for a
total of 6000 pulses
Dropping on each face Dropping on
each corner Toppling (or pushover)
For a total of 12 drops
96 hours steady state humidity at 40 °C
& 93% RH
Temperature range:
20 °C to +70 °C
−
Temperature range:
− 40 °C to +85 °C
Test Specification
40 °C,
−
63